Definition of Radio Controller Breakout Board (light and normal) from Dresden Elektronik. More...
Go to the source code of this file.
Defines | |
| #define | BOARD_RBB_H |
| #define | DBG_DDR DDRA |
| #define | DBG_PIN (1<<PA0) |
| #define | DBG_PORT PORTA |
| #define | DDR_KEY DDRE |
| #define | HIF_IO_ENABLE() do{ DDRC |= 0xD0; PORTC |= 0xC0;}while(0); |
| #define | HIF_TYPE (HIF_UART_1) |
| #define | HWTIMER_REG (TCNT1) |
| #define | HWTIMER_TICK ((1.0*HWTMR_PRESCALE)/F_CPU) |
| #define | HWTIMER_TICK_NB (0xFFFFUL) |
| #define | HWTMR_PRESCALE (1) |
| #define | INVERSE_KEYS (1) |
| #define | LED_DDR DDRE |
| #define | LED_MASK (0x1c) |
| #define | LED_NUMBER (3) |
| #define | LED_PORT PORTE |
| #define | LED_SHIFT (2) |
| #define | LEDS_INVERSE (1) |
| #define | MASK_KEY (0x20) |
| #define | PIN_KEY PINE |
| #define | PORT_KEY PORTE |
| #define | PULLUP_KEYS (1) |
| #define | SHIFT_KEY (5) |
| #define | SLEEP_ON_KEY() |
| #define | SLEEP_ON_KEY_INIT() do{}while(0) |
| #define | SLEEP_ON_KEY_vect INT5_vect |
| #define | TIMER_INIT() |
| #define | TIMER_IRQ_vect TIMER1_OVF_vect |
| #define | TIMER_POOL_SIZE (4) |
| #define | TIMER_TICK (HWTIMER_TICK_NB * HWTIMER_TICK) |
Definition of Radio Controller Breakout Board (light and normal) from Dresden Elektronik.
The Breakout board is a carrier board for the radio controller board family. The transceiver wiring fits the common RCBs. The wiring of the radio and the ATmega is shown below:
AVR AT86RF230
--- ---------
PB4 --> SLPTR
XTAL1/PD6 <-- CLKM
PD4 <-- IRQ (ICP1)
PB5 --> RSTN
PB0 --> /SEL
PB2 --> MOSI
PB3 <-- MISO
PB1 --> SCK KEY: PE5
LEDS PE2:PE4DBG: PA0 - connector J3:1 (ground J3:10)
Fuses/Locks:
LF: 0xe2 - 8MHz internal RC Osc.
HF: 0x11 - without boot loader
HF: 0x10 - with boot loader
EF: 0xff
LOCK: 0xef - protection of boot sectionBootloader:
Start at byte=0x1e000, address=0xf000, size = 4096 instructions/ 8192 bytes| #define SLEEP_ON_KEY | ( | ) |
do{\ EIMSK |= _BV(INT5);\ set_sleep_mode(SLEEP_MODE_PWR_DOWN);\ sleep_mode();\ EIMSK &= ~_BV(INT5);\ } while(0)
| #define TIMER_INIT | ( | ) |
do{ \ TCCR1B |= (_BV(CS10)); \ TIMSK1 |= _BV(TOIE1); \ }while(0)